A lifting beam has a single top attachment point and carries the load in bending, while a spreader beam is suspended from two separate slings and is loaded mainly in compression. The two are frequently confused, but choosing the wrong one for a given load geometry changes how the beam — and the slings under it — actually behave under load.
Flat webbing slings are produced with different eye configurations — standard soft eyes, twisted (reverse) eyes, and endless loop constructions — each suited to particular hitch methods and connection points. Choosing the wrong eye type or connecting it incorrectly to a hook or shackle can concentrate load on a small area of webbing and reduce real capacity below the marked WLL.
Adjustable lifting beams let the lifting points slide or telescope to match different load lengths, but each position usually carries its own separate working load limit rather than one figure for the whole beam. Misreading which position is set — or moving a beam under load — is the main safety issue specific to this type.
Sharp or unprotected edges on a load are one of the most common causes of sudden webbing sling failure, because textile fibres can be cut through quickly under tension where a sling passes over a corner. Protective sleeves, edge protectors and corner pads reduce this risk and should be treated as standard equipment, not an optional extra.
Vacuum and magnetic lifters use suction pads or electromagnets instead of slings to grip flat, non-porous or ferrous loads directly, and depend entirely on an unbroken seal or power supply rather than a mechanical connection. Their unique failure mode — silent, sudden release — makes pre-use checks and power backup arrangements especially important.
A round sling is an endless loop of polyester yarn bundled inside a protective woven outer sleeve, giving it no fixed load-bearing surface — the sling simply rotates in use, spreading wear evenly. This makes it a popular general-purpose lifting accessory, but the outer sleeve hides the load-bearing core, which makes correct inspection especially important.
Collared eyebolts have a shouldered ring at the base that lets them carry a limited amount of angular load, while plain (uncollared) eyebolts are designed for straight vertical pull only. Mixing the two up, or fitting either type loosely, is one of the most common rigging mistakes on site.
A round sling’s rated capacity changes depending on whether it is rigged straight (vertical), choked around the load, or as a basket hitch around the load and back to the hook. The label states the WLL for each configuration, and choosing the wrong one for the geometry of the lift is a common rigging error.
A swivel lifting point rotates and often pivots at the eye, letting the sling leg align itself with the direction of pull instead of forcing the load to bend the bolt. They cost more than a fixed eyebolt but remove the angular-loading problem that causes most eyebolt failures.
The colour of a round sling’s outer cover gives a fast visual indication of its rated capacity for a straight lift, but it is an aid for sorting and quick recognition on site, not the legal or technical basis for using the sling. The sewn-in label is always the document that governs actual use.